We are currently about halfway done with the quarter, and are starting to dig into this box project, I really want to finish early because I wood like to explore 3D printing and wood burning. But I don’t think I will get there, I am currently a little behind. I learned that when measuring , you have to use a T square, if you don’t your going to go back and do it again. I really like the hand saw because I felt like it cut more accurately. The rip cut saw was hard, a slip and your piece would be uneven. Because I had trouble measuring and rip cutting, and I had to continue to slice off parts of the wood. My box is going to be much smaller than what I wanted it to be. I am about to sand on the sanding block, and hopefully soon I can start glueing.