I finished my product this week. It is a teapot. It looks like this:

 

I thought that making it was really cool, and interesting. There were many exiting parts and steps to making this one piece of jewelry.

1) We made a sheet with our designs

2) We went on a site called Vectornator and drew our designs digitally.

3) We printed out our designs.

4) we used wire to trace our printed designs, to bend the wire we used tweezers.

5) We but tape on the sheet and placed our traced wire design on the tape.

6) We then used solder to attach the metals together, at our soldering corner.

7) After we soldered it needed to be touched up, so we used sandpaper to rub of any unnecessary solder.

These were all the long, challenging steps to make on piece of jewelry.

This is a picture describing STEP-FOUR

This is a picture of THE SOLRER CORNER