Finally after I was done with my second switch, I began to work on my third switch. At last! I decided to do a very simple switch because I was running out of time, so I decided to make a push button. A lot of people were making pushing switches, except they attached the push to a swing with rubber bands, because they needed some sort of resistance and a swing gives that. Their design was so that you had to push the swing down onto the base where there was tinfoil, and that’s how the switch worked. However, I wanted to make a different design. Instead of using rubber bands as resistance, I wanted to put my push button on something that would go up and down…. I thought for a while, thinking what could act as resistance. I was browsing through different materials, then I found what I was looking for! A pom-pom would be perfect! I cut out a piece of cardboard for the push button, and put two pom-poms on each end. Then, I used two pieces of cardboard on each side so the push button would stay in place. Finally I put tinfoil over the parts, and I was a ready to hot-glue everything together!