Updates on the box
September27
It has been very busy in tech (working on the box) so it was hard to find time to post but here is were I am so far:
I have now done all the cross-cutting (going perpendicular to the grain) but still need to rip (cut along the grain) because that requires a different saw. We used a miter-box saw to cross cut and we will use a band saw to rip cut.
Here is my wood so far:
Before cutting I had to measure and it took a lot of work to get it correct. To do that we used try-squares.
It feels good to learn about tools.
It was very helpful to see the cardboard model because that’s showed me that my box was too big.
Now I will need to rip cut on the band saw. Then I will:
- Think if I need to replace and remake any pieces (probably and hopefully not)
- Sand wood
- Glue wood
- Decorate the box
- Add dark varnish
- Use flocking powder to decorate inside of box
- Make it have “Eli’s Flashlight” on it (I don’t know how to do that yet, just that we can)