Sawing PVC Pipes

To make your flashlight a specific size you will have to saw it. When you saw you first have to mark where you are sawing, because if you don’t, then you might saw it in the wrong place and get your entire flashlight a few inches or centimeters off. The first time I sawed I misread how long the piece of pipe would be and my flashlight didn’t fit into the box and I had to saw again. When you saw, you need to make sure that you are not pressing down too hard because that will actually make it harder to saw, so as Mr.Calvert says “ look! The saws have these sharp teeth let them use them.” This means that you should let the saws do the hard work for you and you should just move your hand back and forth.

0 comments on “Sawing PVC PipesAdd yours →

Leave a Reply

Your email address will not be published. Required fields are marked *