Building the Flashlight- Technology

In the previous post I talked about making the plans for the flashlight. This will be about building the flashlight. After I finished drawing out the plan I had to get the fittings. Once I knew they were the right fittings, I needed to get all te pieces. I had two positive wires and one negative. I soldered these in the right order and left these in the bag. Then, I had to drill holes to fit the switch (I put it at the top) and the light (which I put in the front, obviously). Then, I had to struggle to fit the light in the hole and fit the switch and closed it all up. Then, I put a switch cover on it and glued it down. The next part would be to decorate…

Leave a Reply

Your email address will not be published. Required fields are marked *