Flashlight

I have finished my flashlight. It was a fun but hard process. Before we were even able to start building, we had to make a diagram. This was pretty hard because we had to measure and draw everything to scale. After this, I had to cut my PVC pipe. This wasn’t that hard because I already had my pipes length and all I need to do was cut it. Next I solder my cricut. I first cut my wires then soldered my cricut altogether. My circuit consisted of two black wires, one red wire, a LED light, a switch and a battery. Once I finished soldering, I just put my wires into my PVC pipe and closed it up. Finally I colored it.

Leave a Reply

Your email address will not be published. Required fields are marked *