We designed our rocket based on information we found online. We chose our fin design because it was a stable fin design and our group thinks it is the most aerodynamic. We have a smaller body because our group thinks that if we have a lighter body, the rocket will fly much further. We have our nose cone design because we think it is the most aerodynamic. 

      We built our rocket using an oak tag around a PVC pipe and wrapping it with electric tape. To make our nose cone, we cut a circle and made a middle point and cut the circle to the middle. Then we curled the circle as thin as we could make it. everyone in our group each made one. The tightest nose cone in our group was picked. We hot glued the nose cone onto our rocket body. Then we drew a fin template for our rocket. We decided we were going to use three fins because there is less drag (weight) on the rocket. We traced the rocket onto cardboard three times and cut them out. We hot glued one fin, then taped it, glued, then taped it and so on. That is how we built our rocket. It was very fun, the research, designing, and building.