Today, I started making my paper with the measurements for my flashlight. I will probably start making my flashlight either on Thursday or on Friday. I think that drawing the measurements is the hardest part of the process because the measurements have to be exact and very precise.

Today, we started making the blueprints for our water proof flashlights. My flash light design is a little hard to explain, so i am attaching a picture below. ‘  

Today I started working on my third switch. My third switch is a diagonal board help up by four paper straws. There is a “basket” made out of small pieces of cardboard covered in tinfoil and there is a board holding everything up. There is a ball made out of  tinfoil and when it rolls…

Today I started working on my second switch. It is a little simpler than my first switch but it still works. This switch is a see-saw. The part where people normally sit is covered in tinfoil. The board that the see-saw is on on is also covered in tin foil. When you move the see-saw…

Today I started making my first switch. It is a board covered in tin foil and then there are two popsicle sticks on the sides. There is is a popsicle stick hot glued on top of both the popsicle sticks, connecting them. There is also a rubber band glued on to the popsicle stick and…

Today I finished soldering. I burned myself on my finger today, too. It hurt A LOT and my finger turned red, but in the end I was fine.

Today I printed out my design and I started soldering today. My design looks good so far and i am very happy.

today we were working on our designs for our charms. I did my initials which are VR. We used Vectornator to make our designs. Mr. Calvert showed us how to use the app to make our designs.

I started tech on Tuesday and so far, it has been really fun and scary at the same time. The people at my table are Nichole, Brody and Tyler. On the second day of tech, Mr. Calvert told us about the safety rolls inside the classroom. One of the rules is “power tools are dangerous,…