My final two blog posts are going to be about my final project in tech which was making a flashlight. First I sawed a PBC pipe and Mr. Calvert gave me the other ones. Next I had to drill two different holes. One hole was for the light and the other was for the switch, both were in my circuit. Which I will explain in my next blog post. Drilling these holes was very scary. How I did it was I positioned the pipe right where I wanted the hole, then locked the pipe in one position so it could not move while I was drilling because that would be very dangerous. Finally I turned the drill on and slowly moved it towards the PVC pipe. Then I had all my pipes done.