I finished my flashlight! I’ll tell you about how I made my diagram. First we took a special type of grid paper. I drew my first cap first. It was really hard. I had to line up all of lines and measure the cap. Each square in the grid was 0.5 inches long. Then I drew my long pipe and I had to draw the overlap with the pipe and cap. Next I drew my other cap on the other side of the pipe. Once I was done with that I had to draw a line to indicate how long my pipe was. After that I drew the spots where my light bulb, switch, and battery were going to go. Finally I included all of the tools I needed to make my flashlight.